12
3.2 Signaldrive in the opposite
direction
In order to pass a red signal in
the oppossite direction, you can
additionally install the Redlight-
LED (
8172410
) as a so called
Redlight. The Redlight function
can be activated in CV50 Bit8
(value 128). If a train drives past
the Redlight-LED first and then
past the ITC-Sender, the signal
status will be ignored and the
locomotive will continue driving
without stopping. The „Redlight-
LED“ should be installed to the
tracks with a distance of max. 9
cm (3.5 inches) to the ITC/IR-
Signal Decoder.
3.2 Signaldurchfahrt in
Gegenrichtung
Um ein „rot“ zeigendes Signal in
Gegenrichtung zu überfahren, kann
eine zusätzliche LED (
8172410
)
als so genannte Rotsperre-LED
angeschlossen werden. Die
Rotsperrfunktion wird in CV50
Bit7 (Wert128) aktiviert. Fährt nun
die Lokomotive zuerst über die
„Rotsperre-LED“ und danach über
den PZB-Sender, wird der Signal-
zustand ignoriert und das Fahrzeug
fährt ohne Halt durch. Die Rotsper-
re-LED sollte in einem Abstand
von max. 9 cm zum PZB/IR-
Signaldecoder installiert werden.
Bremsweg
Stopping Distance
Signaldecoder
Signal Decoder
Rotsperre-LED
Redlight-LED
max. 9 cm
max. 3.5 inch
Abbildung 3: Aufbau der Rotsperre-LED
Illustration 3: Installing the Redlight-LED