Umbaubericht
Lokomotiven
Pict 12+13: Mount and connect the XLS.
Now connect the cables in following way:
Track + = grey/grey
Track - = white/white
Motor + = red/red
Motor - = blau/blau
Light interior = green (you can also connect it ti A2, if you wan’t to switch it separately)
Light front = yellow/brown (the marked cable for front light)
Light rear = yellow/brown (the marked cable for rear light)
D (22V) = black/black
Plug in the 2-pole connector for speaker.
Illumination
Cut the LED lighting board as shown in pict. 14 (each 13,5 cm from outside PCB)
As shown in picture you have to drill a hole with a 7mm drill.
Solder the 2 cables as shown.
Black = +
Green = -
The PCB will fixed with 2 screws 1,5 x 4 .
In traction unit 2 you will mount the other PCB.
Reassemble the traction units in reverse order.
Stand 18.04.2020
Seite 9 / 11