Mastech MS6813 Multi Function Network Cable Tester
10
1.1.3
Debug Mode
In Debug Mode, detail of the connection error is displayed. Condition of every pair of wires is
shown twice in order. With the wire pair indicators and error indicators, the network cable
can be indentified and debugged. Follow the steps:
a)
Connect one end of wire to RJ45 transmitter socket.
b)
Connect the other end of wire to receiver socket.
c)
Power on the Tester, power indicator is on.
d)
Press and hold “TEST” button until all the wire pairs and error indicators are all
on, release the button afterward.
e)
Determine the error from the indicators.
f)
If a wire pair indicator turns green twice (one short, one long), and other error
indicators are off, then the wire pair is in good condition.
g)
If the wire pair malfunctions, the corresponding indicator will flash once and
then turn on (long) again with the error indicator on.
h)
In debugging mode, press and release the “TEST” button to end the debug.
Example: Wire pair 1-2 and pair 3-6 are short circuit. In debug mode indicators will show
as follow:
Wire pair 1-2 flashes green light, wire pair 3-6 indicator and short circuit
indicator flashes red light.
Wire pair 3-6 flashes green light, wire pair 1-2 indicator and short circuit
indicator flashes red light.
4-5 indicator shows green lights (no error)
7-8 indicator shows green lights (no error)
