PRODUCT SHEET
Daily cleaning:
To keep the K-PLAN surface clean, just wipe over with a damp cloth soaked with
common household gel or cream detergents or detergent solutions. Lastly take care to
rinse the bathtub surface thoroughly.
Avoid using solvent-based or particularly aggressive products such as ammonia,
turpentine, trichloroethylene, thinners, etc.
Warning:
This product sheet is in compliance with the provisions of Italian Law No. 126 of 10
April 1991 “Standards concerning consumer information” and Italian Decree No. 101 of
8 February 1997 Executory Decision.
Maintenance:
In the case of: SURFACES WITH DULL AREAS, HALOS OR SMALL ABRASIONS
These marks may be easily eliminated by thorough cleaning with an abrasive detergent
and a Scotch Brite sponge (reg. 3M trademark).
In the case of: SURFACE SCRATCHES
Proceed as above using detergent and the Scotch Brite sponge. If the scratch is still
visible, use emery paper, first wet and then dry.
In the case of: DENTS AND DEEP SCRATCHES
Some severe damage can be fully repaired. Contact Mastella and explain the type of
problem that has arisen to assess whether repair is possible or not.
To respect the environment, at the end of its working life please have the bathtub
consigned to the municipal waste disposal site
12
Surfaces painted with SOFT TOUCH
Clean with normal detergents for surfaces, using a spray product and soft sponge or
cotton cloth. Do NOT use abrasive pads and do NOT use abrasive detergents.
“VANITY PARTY” bathtub 175x111x50 H cm:
The bathtub is made in K-PLAN. It is a compact non-porous material consisting of a
high percentage of natural hydrated aluminium oxide mineral filler and a low
percentage of polyester acrylate resin. It is a strong, hygienic material that is pleasant
to the touch and is particularly suitable for making washbasins, shower trays and
bathtubs. The bathtub weighs 156Kg empty and 486kg filled with water up to the
overflow. Its capacity is 3,30hl up to the overflow and 4,12hl up to the bathtub edge.
