Page 12
FIG. 4
FIG. 5
OPERATION
FIG. 6
FIG. 7
1. Disconnect the tool from the power
source.
2. Push the quick-release lever fully open
with your palm to loosen the flange bolt
(Fig. 5). Remove the flange bolt.
3. Ensure that the adapter and the
drive shaft are clean.
4. Align the grooves on the application
tool with the twelve raised ribs on
the adapter shown in Fig. 6. Put the
application tool onto the adapter.
5. With your gloved hand holding the
application tool, insert and depress
the flange bolt until you hear a click
indicating that the application tool is
secured (Fig. 7).
6. Press the quick-release lever with your
palm to lock the drive shaft (Fig. 8).
FIG. 8
Rib
Groove
NOTICE: Attach the application tool at the
desired orientation for the task at hand.
The shaft is configured so that the
application tool can be attached at 30°
intervals around the shaft, from 0° to 330°.
Summary of Contents for 241-0854
