Page 15
WARNING:
Carefully check the workbench or stand
after mounting to make sure that no movement can occur
during use. If any tipping, sliding, or walking is noted,
secure the workbench or stand to the floor before operating.
CAUTION:
Mounting hardware is not included with
this tool. Bolts, nuts, washers and screws must be purchased
separately.
CAUTION:
If a miter saw stand is used, please
follow all instructions shown in that product’s instructions
for proper mounting.
CAUTION:
For stabilizing the tool the height of
leveling foot (L) can be adjusted. (Fig. 3c)
Mounting instructions:
For stationary use, place the saw in the desired location,
directly on a workbench where there is room for handling
and proper support of the workpiece. The base of the saw
has four 3/8 in. mounting holes (A) (Fig. 3a). Bolt the base
of the miter saw (B) to the work surface (C), using the
recommended fastening method as shown in Fig. 3b.
For portable use:
Place the saw on a 3/4 in. thick piece of plywood (K) (Fig. 3c).
Bolt the base of the miter saw securely to the plywood
using the mounting holes (A) (Fig. 3a) on the base. Use
C-clamps (not included) to clamp this mounting board to a
stable work surface at the worksite (Fig. 3c).
ASSEMBLY
J
F
B
C
I
FIG. 3b
FIG. 3c
WARNING:
To avoid injury from unexpected saw
movement:
• Disconnect the power cord from the outlet and lock the
cutting head in the lower position using the head lock
knob.
• Lock the slide bar in place by tightening slide lock knob.
• To avoid back injury, lift the saw by using designated
carrying handles located on the top of the saw arm and
on the end of the slide bar.
• Never carry the miter saw by the blade guard, power cord,
miter lock lever or cutting arm. Carrying the tool by the
plug cable could cause damage to the insulation or wire
connections resulting in electric shock or fire.
• To avoid injury from flying debris, do not allow visitors to
stand near the saw during any cutting operations.
MOUNTING THE MITER SAW (FIG. 3a-3c)
FIG. 3a
A
B. Miter saw base
C. Work surface
D. Hex bolt
E. Rubber washer
F. Flat washer
G. Flat washer
H. Lockwasher
I. Hex/Lock nut
J. Jam nut
Stationary use
Portable use
L
A
A
A
K
E
H
G
D
Summary of Contents for 240-0028
Page 44: ......
