3
Operating Instructions and Owner’s Manual
Master Forge Wood Pellet Fire Stove
SPECIFICATIONS
Model #
H30XL
DIMENSIONS
Stove Weight
[LBS (kg)]
147 (67)
Stove Dimenions LxWxH
[in. (cm)]
18.25” x 20“ x 32.75”
(46.36 x 50.8 x 83.2)
Air Inlet Pipe Diameter
[in. (mm)]
1.25” (32)
Air Outlet Pipe Diameter
[in. (mm)]
3” (80)
Pellet Hopper Capacity
[LBS (kg)]
30 (13.6)
OPERATION SPECIFICATIONS
Fuel
Wood Pellet
Heats approximately [ft
2
(m
2
)]**
431-646 (40-60)
Carbon Monoxide Produced (g/hr)
0.00
Pellet Consumption Rate High [LBS/HR (kg/HR)]
3.75 (1.70)
Pellet Consumption Rate Medium [LBS/HR (kg/HR)]
1.72 (0.78)
Pellet Consumption Rate Low [LBS/HR (kg/HR)]
1.70 (0.77)
Stove Efficiency
76%
Heat Output Rate [BTU/HR (kW)] - HIGH
23,945 (7.02)
Heat Output Rate [BTU/HR (kW)] - MED
10,965 (3.21)
Heat Output Rate [BTU/HR (kW)] - LOW
10,796 (3.16)
ELECTRICAL SPECIFICATIONS
Electrical Supply Requirements [Voltage /
Frequency / Phase]
120V / 60 Hz / Single
Electric Current During Lighting Phase [Amperes]
3.3
Auger Motor R.P.M.
2.4
*BTU input/output will vary, depending on the brand of fuel you use in your Stove
** Depending on climate zone. Variations in climate and location affect attributes such as stove efficiency
and CO produced.
This manual describes the installation and operation of the brand “Master Forge” wood pellet fire stove. This
stove meets the applicable U.S. Environmental Protection Agency’s emission limits for pellet fired heaters sold
after 2020. Under specific test conditions these stoves have been shown to deliver heat at rates ranging from:
H30XL: 23,945 to 10,796 Btu/hr
