2 |
P a g e
High Pressure Seal Cutter – User Manual
I
NTRODUCTION
The Master-Lee High Pressure Seal Cutter is designed to precisely cut the Swagelok ferrules from a flux thimble or
a stub on the Seal Table. Once attached to a thimble or stub the rotary cutting tool can be moved in .001” increments
to cut through the ferrule without causing damage to the sealing surface. The tool is equipped with adapters to use
on a Flux Thimble, 5/8” Diameter Stub, and 3/4” Diameter Stub.
P
ARTS
L
IST
Part Number
Part Description
Quantity
D1902
High Pressure Seal Cutter Assembly
1
C3007
5/8” Tube Support Bracket
1
C1908
3/4” Tube Support Bracket
1
C1904
Flux Thimble Tube Support Bracket
1
C1910
5/8” & 3/4” Tube Tool Mount
1
C1903
Flux Thimble Tube Tool Mount
1
N/A
Dremel Rotary Tool
1
N/A
Fiber Cutting Wheel (20 pack)
1
N/A
Rotary Mandrel
2
N/A
Pelican Case
1
O
PERATION
I
NSTRUCTIONS
1.1.
Adapter Change Out
1.1.1.
The High Pressure Seal Cutter already comes with the 3/4" adapters installed on
the tool.
1.1.2.
Remove the four (4) 6-32 Socket Head Cap Screws from the face of the tool and
remove Tube Support Bracket as shown in Figure 1.
1.1.3.
Pick desired Tube Support and attach with the four (4) 6-32 Socket Head Cap
Screws.
1.1.4.
If a Thimble Tube Support is used, make sure the Tool Support labeled “FOR
THIMBLE TUBE” is installed. It is attached with two (2) 6-32 Socket Head Cap
Screws and Nylon Lock Nuts as shown in Figure 2.
WARNING
E
NSURE
CUTTING
WHEEL
IS
SECURELY
FASTENED
AND
CENTERED
ON
THE
MANDREL
.
E
NSURE
MANDREL
IS
SECURELY
FASTENED
IN
THE
D
REMEL
T
OOL
COLLET
.
P
ROPER
PPE
MUST
BE
USED
WHILE
PERFORMING
FERRULE
CUTTING
OPERATIONS
.
U
SERS
MUST
STAY
OUT
OF
“
LINE
OF
FIRE
”
IN
CASE
OF
ABRASIVE
WHEEL
FAILURE
.
