4 |
P a g e
High Pressure Seal Cutter – User Manual
1.3.7.
Once the ferrule is almost completely cut through use a flat head screw driver to
split the ferrule to prevent damage to the stub.
1.4.
Cutting Ferrules on a Thimble Tube
1.4.1.
Ensure Thimble Tube attachments are installed.
1.4.2.
Position ferrule above the upper and lower guide on the Tube Support Bracket.
1.4.3.
Once attached, tighten wing nut on the upper guide.
1.4.4.
Use the X & Y dials to move the Dremel Tool close to the ferrule.
1.4.5.
Turn on the Dremel Tool and use the X dial to feed the cutting blade into the
ferrule.
1.4.6.
Use the Y dial as needed to make a vertical cut in the ferrule.
1.4.7.
Once the ferrule is almost completely cut through use a flat head screw driver to
split the ferrule to prevent damage to the stub.
