LEGACY SPA - CONTROLS
28
INITIAL START-UP
When your spa is first actuated, it will go into Priming mode, indicated by “
”
The Priming mode will last for less than 5 minutes (press “Temp” to skip Priming
Mode) and then the spa will begin to heat the spa and maintain the water
temperature in the Standard mode.
Temp (80°F - 104°F / 26°C - 40°C)
The start-up temperature is set at 100F°/37°C. The last measured temperature
is constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only when
the low speed of pump 1 has been running for at least 2 minutes.
To display the set temperature, press the temperature pad once.
To change the set temperature, press the pad a second time before the LCD
stops flashing. Each press of the temperature pad will continue to either raise
or lower the set temperature.
If the opposite direction is desired for a 1 pump unit, release the pad and let
the display revert to the current water temperature. Press the pad to display
the set temperature, and again to make the temperature change in the desired
direction. In a 2 pump unit, temperature setting is accomplished by pressing
up to increase the temperature or down to decrease the temperature.
After three seconds, the LCD will stop flashing and display the current
spa temperature.
Jets I
Touch the “Jets” button once to turn pump 1 on or off, and to shift
between low and high speeds. If left running, the low speed of the pump
will automatically turn off after 4 hours, and the high speed will automatically
turn off after 15 minutes.
Jets 2 (if applicable)
Touch the second “Jets” button once to turn pump 2 on or off. If left running,
pump 2 will automatically turn off after 15 minutes.
Master Spa Parts
Call Us Today: - (920)727 - 1700
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA
Summary of Contents for 2008 Legacy Whirlpool
Page 1: ...2008 OWNER S MANUAL...
