TWILIGHT SPA – CONTROLS
TS 6.1 • TS 7.1 • TS 8.1
28
INITIAL START-UP
When your spa is first actuated, it will go into Priming mode, indicated by
“
” The Priming mode will last for less than 5 minutes (press “Temp” to skip
Priming Mode) and then the spa will begin to heat the spa and maintain the
water temperature in the Standard mode.
Temperature (80°F - 104°F / 26°C - 40°C)
The start-up temperature is set at 100F°/37°C. The last measured temperature is
constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only when the
low speed of pump 1 has been running for at least 2 minutes (temperature is
always current on spas equipped with 24 hour circulation pump). To display the
set temperature, press the “Temp” pad once. To change the set temperature,
press the pad a second time before the LCD stops flashing. Each press of the
“Temp” pad will continue to either raise or lower the set temperature. If the
opposite direction is desired, release the pad and let the display revert to the
current water temperature. Press the pad to display the set temperature, and
again to make the temperature change in the desired direction. After three
seconds, the LCD will stop flashing and display the current spa temperature.
Jets 1
Touch the “Jets” button once to turn pump 1 on or off, and to shift between
low and high speeds. If left running, the low speed of the pump will automatically
turn off after 4 hours, and the high speed will automatically turn off after
15 minutes.
Master Spa Parts
Call Us Today : (920) 727 - 1700
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA
