SPA TROUBLE-SHOOTING GUIDE
38
NOTHING ON THE SPA OPERATES-
1.) Check the control panel display for any messages. If there is a message,
refer to the diagnostic section. There you will find the meaning of the
message and what action is to be taken.
2.) If there is no message on your control panel, check and reset the GFCI and
house breaker.
If the spa does not respond, contact your local service company.
PUMP(S) DO NOT OPERATE -
1.) Press the “Jets” button on your control panel.
If you hear the pumps trying to operate:
A. Pump may need to be primed. See page 16.
If you do not hear anything from the pump, contact your local service
company.
POOR JET PERFORMANCE
1.) Make sure pump is operating
2.) Check that the water level is adequate (up to minimum safe water level side)
3.) Make sure the jets are open.
4.) Check for dirty filter. Clean if necessary.
*The GFCI should be located in a weather proof box
close to the spa, but no closer than 5 ft.
Master Spa Parts
Call Us Today : (920) 727 - 1700
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA
