MASTER SPA - LEGEND SERIES - CONTROLS
Setting the Time
Once the spa has been properly connected the first time, notice the “Time” icon appearing
on the screen.
Press
Then
Select
the hour by pressing
or
(Each press changes the time by 1 hour)
Press
to enter.
Select minutes by pressing
or
(Each press changes the time by 1 hour)
Press
to exit the time setting procedure and enter the optional filter cycle programming.
Press
to exit programming.
Optional Filter Cycle Programming
• You are not required to set filter cycle; however, it is an option available to you. To change the filter
cycle settings:
• Press “Time” “Program/Mode” “Program/Mode” “Program/Mode” within 3 seconds. You will see the
“Program,” “Filter 1” and “Start Time” icons appear on the display.
• Press “Warm” or “Cool” to choose the filter start time hour. Enter the hour by pressing “Program/
Mode”. Press “Warm” or “Cool” to choose the filter start time minutes. Each press changes the start
time by 5 minutes.
• Enter the minutes by pressing “Program/Mode.”
• Press “Program/Mode” to see the “PROGRAM,” “FILTER 1” and “END TIME” icons.
Adjust the time as done above.
• Press “Program/Mode” to see the “PROGRAM,” “FILTER 2” and “START TIME” icons.
Adjust the time as done above.
• Press “Program/Mode” to see the “PROGRAM,” “FILTER 2” and “END TIME” icons.
Adjust the time as done above.
• Pressing “Program/Mode” will enter the new filter cycle times into the system and display
the current water temperature.
• Pressing “Time” at any time during this programming sequence will save the values entered
up to that point and exit programming.
• If you would like to select continuous filtration, set the filter 1 start and end times to be the exact
same time.
Continued on page 38.
37
DO NOT DIVE.
