MASTER SPA - LEGEND SERIES - CONTROLS
Temp Set (80˚F - 104˚F / 26.0˚C - 40.0˚C)
The start-up temperature is set at 100˚F/37.5˚C. The last measured temperature is constantly displayed
on the LCD.
Note that the last measured spa temperature displayed is current only when the pump has been running
for at least 2 minutes.
Warm / Cool
Press the "Warm" or "Cool" button once to display the set temperature. Each time either button is
pressed again, the set temperature will increase or decrease depending on which button is pressed.
After three seconds, the LCD will automatically display the last measured spa temperature.
Time
When time hasn’t been programmed, the TIME icon flashes. To set the time, press “Time” then
“Program/Mode”. Use the “Warm” and “Cool” buttons to adjust time. See previous page for more
detailed instructions.
Program/Mode
This button is used to switch between standard, economy, and sleep modes. Press “Program/Mode” to
enter mode programming, press “Cool” to cycle through to desired mode (LCD flashes until confirmed),
then press “Program/Mode” to confirm selection.
Standard mode
maintains the desired temperature. Note that the last measured spa temperature
displayed is current only when the pump has been running for at least 2 minutes. The “STANDARD”
icon will display until the mode is changed.
Economy mode
heats the spa to the set temperature only during filter cycles. The “ECONOMY” icon
will display until mode is changed.
Pressing “Jets 1” while in Economy mode puts the spa in
Standard-In-Economy mode
, which operates
the same as Standard Mode, then reverts to Economy Mode automatically after 1 hour. During this time,
a press of the “Program/Mode” button will revert to Economy Mode immediately.
Sleep Mode
heats the spa to within 20˚F (11˚C) of the set temperature only during filter cycles.
The “SLEEP” icon will display until mode is changed.
Standby Mode
Pressing “Warm” or “Cool” then “Jets 2” will turn off all spa functions temporarily. This is helpful when
changing a filter. Press any button to exit Standby mode.
Jets 1
Press the “Jets 1” button once to turn pump 1 on or off, and to shift between low and high speeds.
If left running, the low speed turns off after 2 hours and the high speed turns off after 15 minutes.
It may also activate for at least 2 minutes every 30 minutes to detect the spa
temperature (polling) and then to heat the set temperature if needed, depending upon mode. When the
low speed turns on automatically, it cannot be deactivated from the panel; however, the high speed may
be started.
Continued on page 39.
38
DO NOT DIVE.
