MASTER SPA – LEGEND SERIES – LSX 557 - CONTROLS
Initial Start-up
When your spa is first actuated, it will go into Priming mode, indicated by “Pr.” The Priming mode will
last for less than 5 minutes (press “Warm” or “Cool” to skip Priming Mode) and then the spa will begin
to heat the spa and maintain the water temperature in the Standard mode.
43
DO NOT DIVE.
This system is equipped with a 24-hour circ pump. The circ pump and ozone generator (if installed)
run continuously.
Warm/Cool (80˚F - 104˚F / 26˚C - 40˚C)
The start-up temperature is set at 100˚F/37˚C. The last measured temperature is constantly displayed on
the LCD.
Note that the last measured spa temperature displayed is current only when the pump has been running
for at least 2 minutes.
To display the set temperature, press the “Warm” or “Cool” pad once.
To change the set temperature, press the pad a second time before the LCD stops flashing.
Each press of the “Warm” or “Cool” pad will continue to either raise or lower the set temperature.
After three seconds, the LCD will stop flashing and display the current spa temperature.
Jets 1
Touch the “Jets 1” button once to activate pump 1. Press the “Jets 1” button again to turn off the
pump. If left running, the pump will automatically turn off after 15 minutes.
Jets 2
Touch the “Jets 2” button once to activate the pump. Press the “Jets 2” button again to turn off the
pump. If left running, the pump will automatically turn off after 15 minutes.
