DOWN EAST (3 -4 PUMP SYSTEMS) - CONTROLS
Jets 1
Touch the “Jets 1” button once to turn pump 1 on or off. If left running, and the pump will
automatically turn off after 15 minutes.
Jets 2
Touch the “Jets 2” button once to turn pump 2 on or off. If left running, pump 2 will automatically turn
off after 15 minutes.
Jets 3 (if equipped)
This button is used to turn the pump 3 on and off. If left on, this device automatically turns off after
15 minutes.
Light
Press the “Light” button to turn the light on and off. If left on, the light automatically turns off after
4 hours.
L.E.D. Light (if equipped)
Press the "Light" button to turn the light on and off. If you wish to change the “function” of the lights,
turn the lights off, then on within 5 seconds. If you wish to leave the lights in the same “function”
setting for the next use, turn the lights off and do not turn back on for at least 5 seconds.
Mode
Mode is changed by pressing the “Warm” or “Cool” button, then pressing the “Mode” button.
Standard mode
is programmed to maintain the desired temperature. Note that the last measured spa
temperature displayed is current only when the pump has been running for at least 2 minutes. “Std”
will be displayed momentarily when you switch into Standard Mode.
Economy mode
heats the spa to the set temperature only during filter cycles. “Ecn” will display solid
when temperature is not current, and will alternate with temperature when temperature is current.
Sleep mode
heats the spa to within 20°F/10°C of the set temperature only during filter cycles. “SLP” will
display solid when temperature is not current, and will alternate with temperature when temperature is
current.
Filtration
The circulation pump runs constantly for filtration and the ozone generator (if installed) will be enabled.
If the circulation pump operates for more than 15 minutes without proper water flow, it will shut down
and not operate until power to the spa has been reset.
Freeze Protection
If the temperature sensors detect a drop to below 44°F/6.7°C within the heater, the pump(s) will
automatically activate to provide freeze protection. The equipment stays on until 4 minutes after
the sensors detect that the spa temperature has risen to 45°F/7.2°C or higher.
49
DO NOT DIVE.
