DOWN EAST – SOMERSET - CONTROLS
Initial Start-up
When your spa is first actuated, it will go into Priming mode, indicated by “Pr.” The Priming mode will
last for less than 5 minutes (press “Temp” to skip Priming Mode) and then the spa will begin to heat the
spa and maintain the water temperature in the Standard mode.
52
DO NOT DIVE.
Warm/Cool (80˚F - 104˚F / 26˚C - 40˚C)
The start-up temperature is set at 100˚F/37˚C. The last measured temperature is constantly displayed on
the LCD.
Note that the last measured spa temperature displayed is current only when the pump has been running
for at least 2 minutes.
To display the set temperature, press the “Temp” pad once.
To change the set temperature, press the pad a second time before the LCD stops flashing. Each press
of the “Temp” pad will continue to either raise or lower the set temperature.
If the opposite direction is desired, release the pad and let the display revert to the current water
temperature. Press the pad to display the set temperature, and again to make the temperature change
in the desired direction.
After three seconds, the LCD will stop flashing and display the current spa temperature.
Jets
Touch the “Jets” button once to turn pump 1 on or off. If left running, the pump will automatically turn
off after 15 minutes.
Light
Press the “Light” button to turn the light on and off. If left on, the light automatically turns off after
4 hours.
L.E.D. Light (if equipped)
Press the "Light" button to turn the light on and off. If you wish to change the “function” of the lights,
turn the lights off, then on within 5 seconds. If you wish to leave the lights in the same “function”
setting for the next use, turn the lights off and do not turn back on for at least 5 seconds.
