Do Not Dive.
38
SWIM SPA TROUBLE SHOOTING GUIDE
SWIM SPA NOT HEATING
*
If the swim spas heater has failed,
the majority of the time it will trip the
GFCI breaker.
If the swim
spa is not heating and has not tripped the breaker,
please follow these steps:
1.)
Check the control panel for diagnostic messages.
Refer to your swim spa’s
diagnostic message area in previous sections.
Follow steps to alleviate message.
2.)
Check water set temperature at control panel.
3.)
Check for dirty filters.
Clean if necessary.
4.)
Check “heat mode”
the swim spa is set in.
Swim spa should be in standard mode.
5.)
Check the control panel for heater light indicator.
If the light is on,
the
swim spa should be heating.Wait a reasonable amount of time
(approximately 6 hours) to see if the water temperature is changing.
6.) Check to make sure that the pump is primed and all slice valves are open.
7.) Reset power to the swim spa at GFCI breaker.
8.) If swim spa is still not heating, contact your dealer for service.
GFCI IS TRIPPING
The Ground Fault Circuit Interrupter (GFCI) is required, by NEC code
(National Electrician Code), for your protection.The tripping of the GFCI
may be caused by a component on the swim spa or by an electrical problem.
Such electrical problems include, but are not limited to, a faulty GFCI
breaker, power fluctuations, or a miswire. It may be necessary to contact an
electrician if your local dealer recommends doing so.
07MS H2X Owners Manual 1/10/07 11:30 PM Page 38