Do Not Dive.
39
REGULAR MAINTENANCE PROCEDURES
Note:
These are areas that will require the swim spa owner to perform
routine maintenance.These are not areas covered under the warranty
of the swim spa.
CLEANING JETS
The majority of jets in your swim spa can individually be turned on/off. If
any of these jets become hard to turn, it will be necessary to remove the jet
to clean it as grit/sand and mineral deposit may be present.
Jets in the swim spa are removed by turning the collar and then pulling out
the jet.
TO CLEAN JETS
Place the jet(s) in a bucket, fully immerse in white vinegar. Let the jet(s) soak
overnight and then rinse with water. Reinstall the jet(s). It may also be
necessary to clean the grit/deposit from the white jet body using an old
toothbrush.
CLEANING DIVERTER VALVES
Due to mineral deposits and grit/sand that may get into the internal parts of
the diverter valve, it may become hard to turn or freeze up completely. In
this case, it is necessary to remove the handle and cap of the diverter valve.
Before proceeding, make sure the power to the swim spa is turned off.
Turn the cap piece counter clockwise. It may be necessary to put a clean rag
over the cap and turn it with a wrench.
Once loose, the cap and handle can be pulled up out of the white
plumbing fitting.
Wipe down the internal piece that attaches to the cap and handle.
(cont. next page)
07MS H2X Owners Manual 1/10/07 11:30 PM Page 39