53
DO NOT DIVE.
SPA TROUBLE SHOOTING GUIDE
NOTHING ON THE SPA OPERATES-
1.
Check the control panel display for any messages. If there is a message, refer to the diagnostic
section on that model spa. There you will find the meaning of the message and what action is
to be taken.
2.
If there is no message on your control panel, check and reset the GFCI and house breaker.
* The GFCI should be located in a weather proof box close to the spa,
but no closer than 5 ft.
If the spa does not respond, contact your local service company.
PUMP(S) DO NOT OPERATE -
1.
Press the “Jets” button on your control panel.
If you hear the pumps trying to operate:
A. Check that all the slice valves are open. See photo on page 14.
B. Pump may need to be primed. See page 20.
C. Check that the air controls are open. See photo on page 12.
If you do not hear anything from the pump, contact your local service company.
POOR JET PERFORMANCE
1.
Make sure pump is operating
2.
Check that the water level is adequate (up to minimum safe water level side)
3.
Make sure the jets are open and the air controls are open. See page 12.
4.
Check for dirty filters. Clean if necessary.
