Henan Master Machinery Co., Ltd
Tel:(+86)17737606271
www.mastermachinerys.com
14
Disassembly blade
Change the cutting blade with the engine stopped. Remove two bolts
that are setting the protective hood, and then rotate protective hood.
You need to use wrench lock the main shaft to prevent it from
circumgyrating before clockwise sense remove the nut (Leftl). Clean the
blade from dust and dunghill after the finish operation. Check the cutting
blade whether it is normal use or not.
Assembly blade
Check new blade
Make sure the same new cutting blade of style as primary blade. Refer
to the blade of style, please see operation manual.
NOTICE!
Please pay attention to the blade rotate way accord with
direction indicator. Clean the blade and check the blade stability after
assembly the blade, and then screw the nut.
TRANSPORT
Do not place the cutting blade on the ground, to avoid possible
damages during transport of the same. To protect the cutting blade,
swing the blade its maximum upward position by way of the height
adjustment/cutting depth adjustment and lower down the protective
hood as far as possible. If need be, take off cutting blade from protective
hood.
When being transported on vehicles protective hood have to be
secured against rolling, slipping or overturning.
ATTENTION
! The engine must be stopped when using the integrated
transport device. Lubrication of the engine is not guaranteed if the
engine is running when the cutting is in transport position. This could
lead to serious engine damages. Furthermore the danger exists that oil
will spill out of the crankcase breather.
