7 OPERATING LOGIC
.
8 PROGRAMMING MENU
.
9 DISPOSAL
.
10 RESET
.
1 .
1 FAQ
The Up button opens the curtain, the Down button closes the curtain, the Stop button stops the curtain.
7.2 Comands by manual control buttons
If you press one of control buttons for at least 0.5 sec, the manoeuvre starts; if you press one of the control buttons for less than 0.5 sec, the manoeuvre stops.
To actuate motor by hand, move manually the curtain in the desired direction and the motor will complete the manoeuvre. To stop the manoeuvre, imparting a force in the opposite
direction.
7.1 Commands by transmitter
7.3
Actuation of the motor by hand
8.1 Memorization/Deletion of a transmitter
Bring the curtain in a middle position
Press
of a previously memorized transmitter until the curtain makes 2 movements in opening
PROG
Within 8 s press
of the transmitter you want to store / delete: - movement toward OPEN: transmitter STORED
STOP
- movement toward CLOSE: transmitter DELETED
8.2 How to modify both the limit switch
Bring the curtain in an intermediate position.
Switch OFF power supply, wait 2 seconds and switch ON power supply.
Within 8 s press in sequence
of a transmitter already memorized.
STOP-PROG-STOP
After few seconds motor starts the automatic procedure to memorize the limit switches of the curtain.
At the end of the product life cycle, dispose of the device in compliance with local regulations. This product could contain substances that are harmful to human health and the
environment: do not dispose of the product in domestic waste.
Switch OFF power supply.
While you press and hold
switch ON the power supply. The LED will flash quickly.
T2,
Hold
After about 30 sec. the state LED will remain ON to indicate the reset.
T2.
Switch OFF power supply and wait a few seconds.
Switch ON power supply.
Follow the instructions on section 5
?
I can’t memorize the first transmitter.
Reset the motor (see section 9).
The procedure has been done too slowly. When device entries into «transmitter programming» mode, you have 8 sec. to press STOP button of the transmitter you want to store.
Verify that battery of the remote control is charged.
?
When I try to delete a transmitter, the curtain makes two closing movements .
The device has only one transmitter in its memory: this can’t be deleted.
Be sure to have correctly done the deletion procedure.
The procedure has been done too slowly. When device entries into «transmitter programming» mode, you have 8 sec. to press STOP button of the transmitter you want to
delete.
Verify that battery of the remote control is charged.
?
When I try to store a new transmitter, the curtain makes 1 opening movements and 3 closing movements .
The device has memorized the maximum number of storable transmitters (max 40).
When you switch ON the power supply, the LED must lights up briefly. If it does not, check the power supply of the motor.
Be sure to press
within 8 sec. from motor power ON.
PROG
Check the transmitter functionality.
Check if there are other devices that work at the same frequency of the transmitter (e.g. alarms, radio headsets...)
Repeat the procedure with another transmitter.
The motor may be damage and may be necessary to replace the motor.
?
I can’t memorize a new transmitter.
Be sure to have correctly done the memorization procedure.
Verify that battery of the remote control is charged.
Try to do the same operation with another transmitter.
?
When I try to store a new transmitter, the curtain makes two closing movements .
Be sure to have correctly done the memorization procedure.
The manufacturer shall not be liable for damage resulting from improper, incorrect or unreasonable use
All products and technical specifications given in this document are subject to variation without notice.
Unless previously and specifically authorised by the manufacturer, the device must be used exclusively with transmitters produced by the same manufacturer.
