Integrity Bath
–
Model MB-80
R
Operation Manual - BathAire
(SM)
Variable System Control
07-06-18
Page 12 of 16
2071 14
th
Ave – Columbus, NE 68601
800-798-5867 FAX: 402-563-9102
www.mastercarebath.com
Before activating the BathAire
(SM)
1. Remove the SERVICE ACCESS DOOR
2. Remove the AROMATHERAPY ACCESS CAP
3. Insert the selected AROMATHERAPY CARTRIDGE in the
AROMATHERAPY CARTRIDGE HOLDER
4. Securely close the cap prior to turning on the
BathAire(SM).
DO NOT OPEN THE CARTRIDGE,
DO NOT place loose beads or liquids in the
AROMATHERAPY CARTRIDGE HOLDER
Running
the
BathAire(SM)
without
the
AROMATHERAPY CAP securely in place will cause
the system to lose too much air and the aerators
(hydromassage action) will not function properly.
BathAire(SM) ON/OFF button
The BathAire (SM) can be turned on or off by pressing the
blower motor on/off key. Press the button once and the
blower will turn on. Press the button once again and the
blower will be shut off.
BathAire(SM) Air Volume (Water Agitation) Adjustment
Once the BatheAire(SM) is on, it is in an adjustable mode.
The BathAire starts on 60% full speed. To increase or
decrease the air volume, press the MORE AIR/HEAT button
and hold down until the desired level is achieved. The heat
volume is tied to the air volume and is adjusted the same
way.
BathAire(SM) Wave Mode
To create the wave effect, press once for the long cycle, a
second time for the short cycle, and a third time to return to
normal operation.
BathAire(SM) Purge Cycle
The purge cycle comes on automatically 20 minutes after the
blower system has been turned off. It will run for 1 minute.
BathAire(SM) Internal Timer
The BathAire(SM) system has an internal timer that shuts
the blower off automatically after it has run for 20 minutes.
BATHAIRE VARIABLE
SPEED CONTROL
ON/OFF
MORE AIR/HEAT
LESS AIR/HEAT
WAVE
Aromatherapy Cap
