Integrity Bath
–
Model MB-80
R
Operation Manual - Bath Oil/Shampoo Dispensing System
07-06-18
Page 13 of 16
2071 14
th
Ave – Columbus, NE 68601
800-798-5867 FAX: 402-563-9102
www.mastercarebath.com
Bath Oil/Shampoo Dispensing Operation:
1. Press BATH OIL or SHAMPOO button briefly to initiate pump
cycle. If using BATH OIL, allow it to dispense directly into the bath
water. If using SHAMPOO, hold hand under the dispensing head
inside tub wall. If more solution is required, press button a
second time. The amount of bath oil and shampoo dispensed is
preset for economic portions at the factory. If you need more
solution, press the button a second time.
2. If no solution is dispensed from the dispensing head, open the
service door to access the solutions storage. Check the fluid level
in the one liter bottle. If below the intake hose, replace with
MasterCare’s Bath Oil or Shampoo per priming instructions
below.
Note:
1. If you press Bath Oil or Shampoo button for more than five
seconds, it will initiate a pump prime cycle.
3. The normal pump cycle can finish and turn off before the five
seconds occurs, but it will still enter Prime and turn back on.
4. Holding a Button for a longer time will not cause any problems
other than initiating Prime.
5. Pressing any button while a pump is running will shut off the
pump. This is predominately a safety feature for the Prime
operation.
6. Pressing multiple buttons at the same time will turn off any
pumps and be otherwise ignored.
7. A Red LED associated with the pump operation will turn on when
the pump operation is activated.
8. See the maintenance instructions for the purpose and function
of the Green LED.
Replacing One Liter Jugs & Priming Operation:
1. Remove the empty bottle of solutions and replace with
MasterCare’s Bath Oil or Shampoo.
9. Remove the cap and seal under the cap on the bottle of liquid.
10. Insert the foot strainer attached to the cap with dispensing hose
into the bottle so that the strainer foot is on the bottom of the
bottle. If replacing an empty two-liter container, check the
strainer at the bottom of the strainer. Remove any accumulated
debris that can clog it up.
11. To prime, push appropriate button for the solution you are
priming for seven seconds.
CAUTION:
Other brand bath oils and shampoos may be used with
the MasterCare System although re-calibration may be required.
However, some products may not be compatible with the system
and may damage components in the system, thereby voiding the
warranty. MasterCare offers an extended warranty with your use of
MasterCare bathing and Cleaning/disinfection products. Please
contact MasterCare customer service @ 800-798-5867 before using
non-MasterCare products in your system.
BATH OIL
SHAMPOO
SERVICE
ACCESS
DOOR
(REMOVED)
Shampoo
Oil
