Integrity Bath
–
Model MB-80
R
Operation Manual - Disinfectant Dispensing System
07-06-18
Page 14 of 16
2071 14
th
Ave – Columbus, NE 68601
800-798-5867 FAX: 402-563-9102
www.mastercarebath.com
Operating Instructions:
How to Connect the Dispensing System to the MasterCare
Cleaner/Disinfectant Bottle:
1. Remove the cap and seal under the cap on the one liter
jug of cleaner disinfectant.
2. Insert the foot strainer attached to the cap with
dispensing hose into the two liter bottle so that the
strainer foot is on the bottom of the jug. If replacing an
empty one liter container check the strainer at the bottom
of the foot strainer. Remove any accumulated debris that
can clog it up.
3. If first time connection on new install follow “How To
Operate” instructions below to prime the system. As soon
as solution starts to flow from the disinfect wand turn off
the flow control knob.
How to Operate the Dispensing System:
1. Grasp the red handled disinfectant wand and pull up out
of the holder. Point the nozzle inside the tub. To activate,
turn the disinfectant control valve counter clockwise until
fully on.
2. Follow the Operational Instructions provided with the tub
to clean and disinfect it.
3. To deactivate: turn off the disinfectant control valve by
rotating it clockwise until fully shut off.
Heed all label warnings on the cleaner disinfectant
you are using in this dispensing system.
Disinfectant
Wand
Disinfectant Wand
On/Off Valve Behind
the Side Service Door
Service Door
Service Door
Key Latch
