15
INSTALLING BITS & ACCESSORIES IN THE
SDS-PLUS
®
ACCESSORY CLAMPING
SYSTEM
– cont’d
5. Carefully pull outward on the drill bit to
ensure it is properly locked into the
accessory holder.
6. To remove the drill bit from the tool,
simply pull back on the accessory
clamping collar and pull the drill bit out
of the tool.
NOTE:
Insert and remove the chuck and
screwdriver bit adaptor the same way as
the SDS-plus
®
spine drill bit above.
INSTALLING A DRILL BIT IN THE
CHUCK
WARNING:
Never hold the chuck
body with one hand and use the drill
power to rotate the drill body to loosen
or tighten bits. Serious injury may
result.
This drill is equipped with a double sleeve
keyless chuck.
1. Remove the tool plug from the power
source.
2. To open the keyless drill chuck, grasp
and hold the chuck collar (1) with one
hand (Fig. 6). Rotate the chuck body
(2) with the other hand in a counter
clockwise direction (3) until the chuck
jaws (4) open wide enough to accept
the bit (5).
3. Insert the bit into the chuck the full
length of the jaws. Raise the front of
your drill slightly to prevent the bit from
falling out of the chuck jaws.
ASSEMBLY AND OPERATING
!
Fig. 6
Summary of Contents for 054-1277-8
Page 20: ...20 EXPLODED VIEW...