headline bars
continuation tabs
notes
warnings
7
headline bars
continuation tabs
notes
warnings
model no. 058-0051-2 | contact us 1-800-689-9928
6
SAFETY GUIDELINES
•
Paints and solvents may be harmful or fatal if swallowed or inhaled.
Avoid prolonged skin
contact with solvents or paints as they will irritate skin. After any contact, immediately wash off
exposed area with hot, soapy water.
•
Always shut off air supply, drain hose of air pressure and disconnect air supply when not in
use, before changing accessories or when making repairs.
Turn off and detach the air supply,
safely discharge any residual air pressure, and release the throttle and/or turn the switch to its off
position before leaving the work area.
• Use only accessories identified by the manufacturer for the specific tool model.
• When servicing a tool, use only identical replacement parts and/or authorized parts.
• Use only lubricants supplied with the tool or specified by the manufacturer.
• Store the tool out of reach of children and other untrained persons when it is idle.
• CA PROP 65:
This product contains chemicals known to the state of California to cause cancer and
birth defects or other reproductive harm. Wash hands after handling.
WARNING!
• Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in personal injury and
property damage. Save all warnings and instructions for future reference.
• Never spray flammable materials in vicinity of open flame or near ignition sources. Never store flammable liquids or gases
near air compressor.
• Never spray closer than 3' (1 m) to the air compressor. Never spray into the compressor, compressor controls or the motor.
CAUTION!
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
KEY P
AR
TS DIAGRAM
No.
Description
G
Finger lever
H
Needle chucking nut
I
Glass jar with lid and fluid connector
(22 cc)
J
Glass jar with lid (22 cc)
K
Air inlet
B
I
J
E
F
A
H
K
C
D
G
WARNING!
If any part is missing or damaged, do not use the product until the missing or damaged part has been replaced.
KEY PARTS DIAGRAM
No.
Description
A
Air brush
B
Nozzle
C
Fluid needle
D
Housing
E
Protective cap
F
Adjustment screw
