headline bars
continuation tabs
notes
warnings
13
ATTACH/REMOVE THE GRASS
COLLECTION BAG
(fig 5)
1. Remove the pre-installed mulching insert before
attaching the grass collection bag to the mower.
2. Use one hand to lift the rear-discharge door; use
your other hand to hold the handle bar of the grass
collection bag, and align the rods on the grass
collection bag with the slots on the mower to
assemble it.
3. To remove the grass collection bag, just lift the
rear-discharge door and remove the rods of grass
collection bag.
ADJUST THE CUTTING HEIGHT
(fig 6)
Pull out the cutting-height-adjustment lever from the
slot, then move it forward or backward to adjust the
cutting height
(fig 6a)
. The mower has five slots which
can adjust the cutting height from about
1 1/2 to 3” (3.8 to 7.6 cm). Do not place the lever out of
the five slots
(fig 6b)
.
TO ATTACH THE BATTERY
(fig 7)
1. Open the protective cap of the battery
compartment.
2. Align the raised portion on the battery pack with
the grooves inside of the battery compartment, and
then slide the battery pack onto the mower.
3. Ensure that the battery-release button on the
battery pack snaps into place and the battery pack
is secured to the tool before beginning operation.
OPERA
TING INSTRUCTIONS
fig 5
Rear-discharge
door
Grass collection bag
Handle bar
1
2
2
fig 6a
Cutting-height-
adjustment lever
X
X
fig 6b
WARNING!
• Keep your feet away from the deck when adjusting its height.
• To avoid the possibility of accidental starting, always take care not to activate the start lever when you are
attaching the battery pack or performing other adjustments to the tool.
FPO
NOTICE:
Two batteries should be used together to start the mower. The mower cannot be used with only
one battery.
