4
5
model no. 299-3118-4 | contact us 1-800-689-9928
TECHNICAL SPECIFIC
ATIONS
SAFETY GUIDELINES
TECHNICAL SPECIFICATIONS
*CFM: Cubic Feet per Minute
1.5
4.0
135
6 U.S. GALLONS (22.7 L)
OIL-LESS
UNIVERSAL
120 V, 60 Hz, 12 A
36 LB 6 OZ (16.5 KG)
SJT 16 AWG/72" (1.83 m)
2.8
RUNNING HP
TANK SIZE
AIR DELIVERY (CFM*) @ 40 PSI
AIR DELIVERY (CFM*) @ 90 PSI
MAXIMUM PRESSURE (PSI)
PUMP DESIGN
MOTOR
POWER
WEIGHT
POWER CORD
This manual contains information that relates to
PROTECTING PERSONAL SAFETY
and
PREVENTING EQUIPMENT PROBLEMS
.
carefully and understand it thoroughly before using the product. The symbols listed
below are used to indicate this information.
IMPORTANT!
Installation, operation or maintenance information that is important but not hazard related.
It is very important to read this manual
CAUTION!
Potential hazard that may result in moderate injury or damage to equipment.
WARNING!
Potential hazard that could result in serious injury or loss of life.
DANGER!
Potential hazard that will result in serious injury or loss of life.
Safety Advice
1.
RISK OF FIRE OR EXPLOSION.
2.
RISK OF ELECTRIC SHOCK.
Do not expose to rain. Store indoors. Hazardous voltage.
Disconnect from power source before servicing. Compressor must be grounded. Do not
use grounding adaptors.
3.
RISK OF BURSTING.
Make sure the regulator is adjusted so that the compressor outlet
4.
RISK OF PERSONAL INJURY.
Never spray compressed air or material at self or others.
5.
RISK OF BURSTING.
Check the maximum pressure rating in the manual or identification
6.
Do not adjust the pressure switch or safety valve for any reason. They
RISK OF BURSTING.
Do not spray a flammable or combustible liquid or paint
pilot lights or in a confined area. The spray area must be well-ventilated.
Keep compressor at least 20' (6 m) away from spray area. Do not carry and operate the
compressor or any other electrical device near the spray area. Never smoke when spraying.
Use a minimum of 25' (7.6 m) of hose to connect a spray gun to the compressor.
near sparks, flames,
.
pressure is set lower than the maximum operating pressure of the spray gun or tool. Before
starting the compressor, pull the ring on the safety valve to make sure the valve moves freely
(see diagram on page 17). Drain water from tank after each use. Do not weld or repair tank.
label. The compressor outlet pressure must be regulated so that it does not exceed the
maximum pressure rating. Relieve all pressure in the hose before removing or attaching
accessories.
have been preset at the factory for this compressor’s maximum pressure. Tampering
with the pressure switch or the safety valve may cause personal injury or property damage.
