Making an angle cut (Fig. 12)
To cut a tile at an angle other
than 90˚:
1. Fit the tile (1) into the mitre
gauge (2) and rest it against the
adjustable work fence (3).
2. Turn the saw ON and use the
45˚ mitre gauge to push the tile
towards the blade.
Making a bevel cut (Fig. 13)
1. Raise the tilting table to one of the
three tilting positions.
2. Secure the tilting table using the
attached supports. Make sure the
tilting table is stable.
3. Turn the wet tile saw ON and use
the mitre gauge to push the tile
towards the diamond-tipped tile
cutting blade.
Note: Use the two support braces on
the bottom of the tilting table to raise
and support the tilting table when it is
at an angle.
VII. Operation - continued
14
Fig. 13
Fig. 12
2
3
1
MC_WetTileSaw 55-6829 E 3/17/05 4:53 PM Page 14