E
XTRACTOR
M
AINTENANCE
After each use:
1
. Drain recovery tank after each use.
2
. Remove all soil and debris from the
recovery tank.
3.
Flush out recovery tank with clean
water.
End of day:
1.
Pour 2 gallons of clean hot water in
the solution tank. Turn the pump
ON
and flush the entire system for about a
minute to prevent alkaline build-up.
Using hose provided, drain tank into a
bucket or floor drain.
2.
Relieve the brush pressure. Clean
debris from around brush and brush
tunnel. This will be easier if you remove
the brush.
3.
Clean vacuum shoe with stiff wire.
CAUTION: DO NOT
leave water in tanks
over night or store with water in tanks.
After repeated use:
Spray Nozzles:
Remove and clean the
spray nozzles of any debris or build-up.
Replace when necessary. When
replacing fitting nozzles, they should be
positioned parallel to the brush.
Solution Filter:
After 4 to 6 uses,
remove the in-line solution filter (located
in solution tank) and clean with a small
brush and rinse.
Brush:
Clean the brush of any debris.
Solution Lines and Fittings:
Flush
extractor at least once a month with a
solution of 1 part water to 3 parts
white vinegar in order to neutralize the
alkaline residue left by the cleaning
solution.
Accessory Disconnect:
Spray with sil-
icone lubricant to prevent coupler from
sticking.
Pump:
Follow procedure used above on
solution line and fittings to flush out
pump. In order to service the pump,
contact the factory or authorized service
center. (
See Trouble Shooting Guide Pg 8)
Vacuum Motor:
Carbon brush mecha-
nisms holder should be replaced after
operating 700 hours or when carbon
brushes are worn down to
3
/
8
" in
length. Replace both brushes at the
same time.
To Replace and Install
Brush:
1.
Remove the
screw next to the
brush pressure
lever.
2.
Remove the
brush holder and
brush.
3.
When installing the brush, make
sure the centering pins on the brush
are properly placed in the holes of the
drive pulley.
4.
Re-insert the brush holder securely,
replace the screw tightly.
C
LEANING
T
IPS
Disconnect the power cord from the outlet before working on this unit
C
AUTION
:
P
AGE
6
Pre-Test:
Pre-test an area so cleaning problems
will not develop during cleaning or after
the carpet is cleaned. Not all products
can be safely used on all fibers and dyes.
1.
Mix the cleaner you are using
according to directions and select an
inconspicuous area, such as a corner,
behind a chair etc.
2.
Place approximately 1 teaspoon of the
mixed solution on a spot about the size of
a nickel. Work solution in with fibers.
3.
Press a clean white cotton cloth
against the wet spot and hold it there
for about 10 seconds. Examine the
cloth to see if any dye has transfer.
4.
Examine the wet spot carefully to
make sure there is no color change to
the carpet that did not appear on the
cloth.
Pre-Treat Heavily Soiled
Area:
Pre-treat heavily soiled carpet or areas
of concentrated foot traffic with pre-
spotting or pre-spray chemical. If a spot-
ter is used, follow label directions exact-
ly.
DO NOT
allow to dry on carpet as it
may damage the carpet permanently.
After Cleaning:
After cleaning the carpet when replac-
ing the furniture, place a small square
of styrofoam under the furniture legs to
prevent moisture from damaging the
finish or rusting metal slides.
