SET-UP SCREENS
RESET FACTORY SETTINGS
Returns all settings to the original
factory settings. Use the ENTER but-
ton to activate the reset mode. Press
the HOME button to exit.
BRIGHTNESS CONTROL
Achieved by adjusting the light lev-
els for both DAY and NIGHT. The sys-
tem will activate the NIGHT lighting
when the navigation lights are on. Use
the ENTER button to select the DAY
and NIGHT slide bars. The up and down
buttons control the adjustment. Press
the HOME button to exit.
ADJUST FUEL ALARM
Also adjusted in the SETUP MENU.
Use the ENTER button to activate the
FUEL ALARM edit screen. Press the
HOME button to exit.
ADJUST SHALLOW ALARM
Also adjusted in the SETUP MENU.
Use the ENTER button to activate the
Depth Alarm Edit Screen. Use the UP
and DOWN arrows to set the desired
depth. Press the HOME button to exit.
UPDATE VIPER
The BIG software may be upgraded
by copying the new software to a USB
Flash Drive and inserting it into the
USB port located at the helm. The file on
the flash drive must be named: Viper.
App.mem. Press the ENTER button to
activate the update or turn the ignition
OFF and then ON. When the install is
complete, the BIG will reset and auto-
matically resume normal operation. Be
sure to remove the flash drive to avoid
an update on the next ignition cycle.
SPEEDOMETER CALIBRATION
Press the ENTER button, then use
the UP and DOWN buttons to change
the speed. This must be done while us-
ing a GPS or radar gun as a reference.
Press the HOME button to exit.
SET UINTS
[English or Metric]
To enter the Unit Selection Screen,
press the ENTER button. Use the UP
and DOWN buttons to highlight Eng-
lish or Metric. Press the ENTER button
again to select. Press the HOME button
to exit.
2011 Owners Manual...Instrument Gauges and Switches...Page 5-19
Summary of Contents for prostar 190 2011
Page 26: ...Guide to Individual Models 2011 Owners Manual Guide to Individual Models Page 4 1...
Page 81: ......
Page 93: ......
Page 105: ......
