OVERVIEW
SPECIFICATIONS
SAFETY INSTRUCTIONS
EXTENSION CORDS
WARNING:
Check extension cords
before each use. If damaged, replace
immediately. Never use tool with a
damaged cord since touching the
damaged area could cause electrical
shock, resulting in serious injury.
CAUTION:
Keep the extension
cord clear of the working area. Position the
cord so that it will not get caught on
lumber, tools or other obstructions while
you are working with a power tool.
MINIMUM GAUGE FOR EXTENSION CORDS
Ampere Rating
Total Length Of Cord
(When using 120 volts only)
More Than< >Less Than
25ft. 50ft. 100ft. 150ft.
0
6
18 16 16 14
6
10
18 16 14 12
10
12
16 16 14 12
12
16
14 12
Not
Recommended
before using. Many accidents are caused by
poorly maintained tools.
9. Use only accessories that are recommended
for this tool. Accessories that may be suitable
for one tool may become hazardous when used
on another tool.
Use a proper extension cord. Only use cords
listed by Underwriters Laboratories (UL).
Other extension cords can cause a drop in
line voltage, resulting in a loss of power and
overheating of tool. When operating a power
tool outdoors, use an outdoor extension cord
marked “W-A” or “W”. These cords are rated
for outdoor use and reduce the risk of electric
shock.
Page 7
Page 6
Item#:
Motor:
120V~, 60Hz, Universal
Running Horsepower:
1.5 HP
Amperes:
13 A
Tank Size:
6.0 U.S. gallons
Air Delivery (CFM*)@40 PSI:
4.0
Air Delivery (CFM*)@90 PSI:
3.0
Cut-in Pressure(PSI):
145
Cut-out Pressure(PSI):
175
Pump Design:
Oil-free, Direct Drive
Power Cord:
SJ 16AWG × 12 ft
Weight:
ELECTRICAL SAFETY
Handle
Motor & Pump
Tank Drain
Power Switch
Regulator
Safety Valve (Not Visible)
Tank
Quick Couplers
Tool Gauge
1. Avoid body contact with grounded surfaces
such as pipes,radiators, ranges, and
refrigerators. There is an increased risk of
electric shock if your body is grounded.
2. Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
3. Do not abuse the cord. Never use the cord
to carry the tool or pull the plug from an outlet.
Keep the cord away from heat, oil, sharp
edges, and moving parts.
4. Replace damaged cords immediately.
Damaged cords increase the risk of electric
shock.
Grounded
outlet
Grounding Pin
Plug
207-1508
This compressor should be used on a
nominal 120V grounded circuit. Use a power
cord that is equipped with a grounding plug.
Verify that the compressor is plugged into an
outlet that has the same configuration as the
plug. Do not use an adaptor with this
compressor.
Note
Tank Gauge
29.3 lbs
