Tool Compatibility Chart
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions.
Read all instructions and follow them with use of this product.
Always ensure the use of appropriately matched air tools with your air compressor. Be
sure that the air compressor being used can supply the appropriate volume, pressure and
delivery rate of air to the tool(s) without running continuously. Using tools or combinations
of tools that, together or separately, require more than the air compressor can deliver will
void the air compressor guarantee/warranty.
Compatible compressor and air tool - proper usage and operation
Important Information
Page 9
Page 8
PRODUCT FE
207-1508
ATURES
Electric Motor
The motor is used to power the pump. It is equipped with a thermal overload protector.
If the motor overheats for any reason, the thermal overload protector will shut it down in
order to prevent the motor from being damaged.
Air Compressor Pump
The pump compresses the air and discharges it into the tank via the piston that moves up
and down in the cylinder.
Safety Valve
This valve is used to prevent the compressor from building too much pressure. If the
pressure reaches the preset level of the motor, it will automatically pop open. You can also
pull the ring on the valve to open manually.
Power Switch
This switch turns the compressor on and off manually. ALWAYS set this switch to the OFF
position when the compressor is not being used and before unplugging.
Air Pressure Regulator
The regulator is used to adjust the pressure inside the line to the tool that is being used.
Turn the knob clockwise to increase the pressure and counter-clockwise to decrease the
pressure.
Tank Pressure Gauge
The gauge measures the pressure level of the air that is stored in the tank. It cannot be
adjusted by the operator and it does not indicate the pressure inside the line.
Tool Pressure Gauge
The gauge measures the regulated outlet pressure.
Air Outlet (Universal Coupler)
The outlet is connected to the 1/4” (6.4 mm) NPT air hose.
Tank Drain
The tank drain is used to remove moisture from the air tank after the compressor is shut off.
Air Tank
The tank is where the compressed air is stored.
Power Cord
This compressor should be used on a nominal 120V grounded circuit. Use a power cord
that is equipped with a grounding plug. Verify that the compressor is plugged into an
outlet that has the same configuration as the plug. Do not use an adaptor with this
compressor.
This air compressor is ideal for a wide range of jobsite applications. The 6 gallon design
provides optimum pressure. It features a 1.5 HP universal motor and oil-free pump.
The procedures described in this manual are solely for this 6 gallon air compressor
at a maximum pressure of 175 PSI.
