20
REWINDING SPOOL FROM BULK LINE (Use only 0.065” diameter line)
To install bulk line, follow the steps below.
1. Turn off the trimmer and remove the battery.
2. Press the release tabs on the line spool cover and remove the cover by
pulling it straight off.
3. Remove the spool from the tool and remove and discard all line on the spool.
4. Insert one end of the bulk line into the hole in the spool. Hold the line in the
hole and pull the rest of the line through the slot in the spool.
5. Wind the bulk line onto the spool in the direction of the arrow on spool
until it is nearly full.
6. Insert the line end through the eyelet in the spool hub. Press the spool down
and relocate the spool cover, ensure the release tabs lock on both sides.
7. Reinstall battery pack and turn on the trimmer, adjusting the line length to
ensure that satisfactory cutting is maintained.
Summary of Contents for 267-3333
Page 24: ...24 ...