The 6230 is a solid steel body lock using the ProSeries
®
standard ball
bearing locking mechanism. Disassembling for servicing is similar to the
rekeyables and may be accomplished by following the steps listed below
(refer to diagram at right for parts and orientation).
• Use the key to unlock the shackle, A. (If the key is unavailable you will
have to use another method to unlock the shackle).
• Use a 7/64" hexagonal wrench to remove the mounting screw located
inside the toe side shackle hole.
• Holding the trap door, D, in place, lock the shackle, A, into the padlock
body. (This relieves pressure on the extension.)
• Remove the trap door, D, and the nut, F.
• Remove the cylinder, C.
• Remove the extension, E.
• Remove the locking ball bearings, B, and shackle, A.
The order may be reversed to reassemble the lock. A light application of
assembly grease may be used to hold the ball bearings in place during
assembly.
If the lock only needs to be rekeyed, it is not necessary to remove the
extension, ball bearings, or shackle.
Two functions are available in the locks, NKR (Non Key Retaining) and
NRK (Non Removable Key) and both functions are accomplished as a
design feature of the extension.
The NKR, non key retaining, function extension used in the lock has a
projection on one side. You should note the orientation of this projection
when removing the extension so that you can easily reinstall it during the
reassembly process.
The NRK, non removable key, function extension does not have a
projection to help with orientation and you will have to rely on the
position of the half-moon shaped actuator that the tail of the cylinder
contacts.
See component parts list on page 6.
ProSeries
®
6230 Locks Service Procedure
3
A
G
B
E
C
D
F