The 6270 is a solid steel body lock. Disassembling for servicing is unique
for this version and may be accomplished by following the steps listed
below (refer to the diagram at the right for parts and orientation).
• Loosen or remove the cylinder mounting screw on the back of the lock
body with a 3/32" socket wrench.
• Use the key to unlock the shackle. (If key is unavailable you will have to
use another method to unlock the shackle).
• Pull on the cylinder to remove it.
• For rekeying, loosen the set screw, (1.5 mm), inside the last pin chamber
to allow 180° rotation of the plug.
• Align pin chambers in plug with service holes in the bottom of the shell
to remove existing bottom pins and replace with new combination.
• Rotate plug to key pull position and tighten the set screw in the last pin
chamber.
• To exchange the cylinder, remove the roll pin at the back of the plug,
remove the shackle and install shackle on a new cylinder.
The order may be reversed to reassemble the lock.
This lock is available with the ProSeries
®
K6000 or K7000 key.
The 700A keyway is available for keying alike to other brands of locks
which may be found in the field.
See component parts list on page 6.
ProSeries
®
6270 Locks Service Procedure
4
A
C
