INSTALLATION
14
July 2010 / DC Distribution / EN
6.4 MASTERCONNECT
The DC Distribution belongs to the MasterConnect
range. These devices link to each other on the DC
connectors directly by pushing them together.
See figure 12.
Figure 12: DC Distribution (right) connected with MasterShunt (left)
6.5 SYSTEM
EXAMPLE
1 DC Distribution
2 MasterShunt
3 Battery
4 Terminator for MasterBus
5 Display for MasterBus data
6 Charger
7 Inverter
8 Load fuse
9 Load
10 DC wiring
11 MasterBus wiring
Figure 13 shows an example of the DC Distribution
in combination with the MasterShunt. Note the serial
connection between the MasterBus devices.
Connect two or more MasterBus devices with
MasterBus cable. Put two MasterBus terminators at
the two ends of the network. Refer to section 4.3 to
see further details on how to set up a MasterBus
network.
NOTE:
Always place two terminators, one at each
end of the MasterBus network.
Figure 13: System example
