background image

FTJ1200  2 03/16/20

           

IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING

BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING 
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.

It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsiblity of 
the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are 
lost or not legible, contact Matco for replacements. If the operator is not fluent in English, the product and safety instructions shall be 
read to and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that 
the operator comprehends its contents.

THE NATURE OF HAZARDOUS SITUATIONS

The use of portable automotive lifting devices is subject to certain hazards that cannot be prevented by mechanical means, but 
only by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in 
the use and operation of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment 
and its proper use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads, 
overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not 
designed.

METHODS TO AVOID HAZARDOUS SITUATIONS

•  Read, study, understand & follow all instructions before using.
•  Inspect the jack before each use.  Do not use Jack if damaged, altered, modified, in poor condition, or has loose or missing 

hardware or components.  Make corrections before using.

•  Consult the vehicle manufacturer for the transmission's center of balance.
•  Never use a power tool to activate the saddle tilt screws.  Operate by hand or socket wrench.
•  Secure the transmission to the jack's saddle with the anchorage restraint system provided before raising or lowering the 

transmission.  

•  Center load on saddle.  Be sure setup is stable before working on vehicle.
•  Support the engine with a stand before unbolting the transmission from the engine.
•  User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
•  Do not use jack beyond its rated capacity.  Do not shock load.
•  Use only on a hard level surface capable of supporting the load
•  Adequately support the vehicle before starting repairs.
•  Use of this product is limited to the removal, installation and transportation in the lowered position, of transmissions, transfer 

cases and transaxles.

•  Do not use any adapters unless approved or supplied by Matco.
•  Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the 

manufacturer's authorized representative.

•  Do not crawl under transmission or place any part of your body under transmission at any time.

•  Before moving, lower the load to the lowest possible height, ensure the load is centered and secure with a load restraint device.
•  Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.

CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS

Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS, 
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS 
SITUATIONS could cause accidents resulting in serious or fatal personal injury and/or property damage.

This is the safety alert symbol. It is used to alert you 
to potential personal injury hazards. Obey all safety 
messages that follow this symbol to avoid possible 
injury or death.

WARNING:

 Indicates a hazardous 

situation which, if not avoided, could 
result in death or serious injury.

WARNING

WARNING

WARNING

WARNING

WARNING: 

This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer 

and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

FTJ1200 1200 LBS. FLOOR STYLE TRANSMISSION JACK

WARNING

Summary of Contents for FTJ1200















Reviews: