Rev.
Descrizione
Redatto/Gestito
Approvato
Cod.Ident.
Pagine
Data Em.
0.6
Manuale Istruzioni
GN
UTEC
B041.M01.EN
4
/47
07/2014
1.06
MODIFICATIONS AND ENCLOSURES OF THE INSTRUCTIONS MANUAL
Il This manual reflects the state at the time of the launch of the machine on its market. If any modifications, improvements or
adjustments have been made since machine supply the Manufacturer does not have to intervene on the marketed machine
and will not consider the machine or the manual deficient or inadequate.
1.07
CONSTRUCTOR IDENTIFICATION
See the front page headline
1.08
MACHINE IDENTIFICATION DATA
On the identification nameplate of the machine are reported the
identification data and the electrical characteristics.
1.09
EC STAMP
SEE EC DECLARATION
1.10
USAGE
Machine or instrument usage:
This Gyratory Compactoris used to simulate and reproduce the real compaction conditions under actual road
paving operations, hence determining the compaction properties of the asphalt. Such compaction is achieved by
combining the rotary action and the vertical resultant force applied by a mechanical head.
Appropriate uses: Those defined in standard
( UNI EN 12697-10, UNI EN 12697-31 / ASTM D6925 / AASHTO T312).
This appliance is for the exclusive use which it has been conceived for. Any other use is considered improper and
therefore negligent. Machine use is allowed only in places free from danger of explosion or fire.
During operation check for conditions of danger.Immediately stop the machine should it be working irregularly,
and consult the authorised dealer’s Sales Service department. It is the Client’s responsibility to verify at the time
of installation and use that no conditions of use arise which are different to those indicated. Refer to the
Constructor when in doubt.
1.11
OPERATORS
DANGER
WARNING
The use, transportation, installation, maintenance, demolition and disposal of the
appliance are only permitted to “QUALIFIED PERSONNEL”. This
manual is exclusively aimed at “QUALIFIED PERSONNEL” and contains the
necessary information for machine use.
”QUALIFIED PERSONNEL” means people who, due to their training, experience and education, as well as
knowledge of the relevant standards, limitations and measures, have been authorised by the “PLANT SAFETY
MANAGER” to carry out any necessary activity and are able to recognise and avoid any possible danger.
The manufacturer recommends that the instructions, procedures and recommendations in this manual and the
work safety legislation in force be scrupulously adhered to, even with the use of appropriate protection devices
(whether individual or part of the machine).
Knowledge and respect of the instructions, safety warnings and danger in this manual are all necessary for
installation, operation, management and machine maintenance with a minimal risk.
The “PLANT SAFETY MANAGER
” has the following responsibilities and duties:
- To know the machine functions, its commands, safety
and protection devices, possible dangers of use and all
the information in this manual in detail. This
knowledge can only be gleaned from detailed reading
of this manual.
- Correctly train and educate the “QUALIFIED
PERSONNEL” before allowing them access to the
machine. The personnel must also be exhaustively
trained with regards to the machine’s protection
devices.
- To know the safety legislation in force in detail in
order to operate the machine
- To recognise the “QUALIFIED PERSONNEL” for
transportation, handling, installation, use, maintenance,
disposal, etc.
- Ensure the machine’s safety devices are not
tampered with or removed and are checked on a daily
basis. Provide the operator appropriate individual
protection devices according to the laws in force.
- The constructor is available for clarification, assistance and training and declines all responsibility for damage to
things or people resulting from improper, incorrect and negligent use by untrained personnel.
