Installation
Page 10
3.3.2
Installation of the universal joint shaft
Comply with the instructions in the operating manual provided by the manu-
facturer of the universal joint shaft.
Mount the universal joint shaft as described in the original manual provided
by the manufacturer of the universal joint shaft.
Switch off the tractor and remove the ignition key before mounting or dis-
mounting the front PTO shaft.
1.
Insert the universal joint shaft through the protective tube and press the locking pin
(locking ring) on the outer fork. Keep the locking pin depressed.
2.
Slide the outer fork onto the profile stub of the mid-mount PTO shaft of the tractor
and release the locking pin (locking ring).
3.
Slightly move the universal joint shaft back and forth until the locking pin audibly
locks in place.
4.
Repeat steps 1 to 3 to attach the universal joint shaft on the front drive shaft tube.
5.
Fix the front protective tube on the front protective tube holder with screws and with
the rubber strap on the rear.
3.4
Mounting the rear hydraulic extension kit
Mount the holder with the connection plugs on the front of the front power system (tapped
bores are present) and lay out the hydraulic hoses along the tractor frame and connect
them to the connections available on the tractor side.
Fig. 6: Hydraulic extension kit
Holder with connection
plugs, front
