Installation
Page 7
3
Installation
Switch off the tractor and remove the ignition key.
Enter the vehicle chassis number of the front power system in section 6 of
this operating manual.
3.1
Installation of the front power system
Start the installation by fitting the two-piece attachment bracket on the front on the tractor
frame. The attachment bracket is fastened on the tractor frame on the front and side with
the bolts included in the scope of delivery.
Fig. 1: Attachment bracket
The actual front power system is only hooked into the provided aperture on the attach-
ment bracket with the cross-member of the front power system and locked with the two
angle bolts (left/right) on the lugs. The arrest nuts on the lugs can be omitted for faster
dismounting (e.g. frontloader). However this can result in higher noise levels.
Connect the hydraulic lines of the front power system to the hydraulic lines available on
the tractor side (lift, lower). Use cable ties to fix the hydraulic hoses in place along the
length of the tractor frame.
Attachment
bracket
