Maintenance
Page 10 of 14
6
Maintenance
Danger!
The implement can fall over.
Only perform service and maintenance tasks when
the harrow is on level ground
the harrow is mounted on the tractor and
Attention!
Properly reattach all protective devices that have been
dismounted after executing the maintenance tasks.
Note!
After the first 5 hours of operation check all screw and
bolt connections.
Subject the harrow to regular maintenance
Only use lubricating grease, do not use oil to lubricate
moving parts.
6.1
Maintenance schedule (overview)
Time interval
Activity
After the first 5 operating hours
Check all screw connections and bolt connections.
Tighten any loose screws, and secure any loose bolt
connections with spring cotter pins.
Daily or before each use
Check the safety elements and moving parts for wear.
Replace worn or defective parts, as needed
For the chassis version, check the air pressure of the casters
and adjust the air pressure if necessary.
After each use
clean the entire implement.
After 25 work hours
Check the moving parts:
Pendulum axle of the harrow
Casters of the feeler wheels
