16
MUSTS5003_05 20211101
4
5
6
8
10
17 & 20
22
Getting off the Tek RMD
While getting off the Tek RMD do not use the joystick or remote control and do not drive the device,
other than as instructed below:
1.
Move near the desired seating spot. Decrease the speed to Level 1.
ATTN:
-
Continue to
2
if your unit has
Gas spring
(for Tek RMD04, Tek RMD08)
-
Continue to
4
if your unit has
Linear motor
(for Tek RMD02, Tek RMD06)
Gas spring system:
2.
Make sure that the belt activation and remote-control activation buttons are switched off (red led
will be off).
3.
Press the gas spring handle lever and gently push yourself down until you reach the foldable transfer
board.
Linear motor system:
4.
Press the belt/linear motor activation button.
5.
Press the left handle lever until you are down low enough to reach the foldable transfer board.
All units:
6.
Hold one of the handles on the transfer board covers. Pull up and back to open. Move further down
until the sling cushion touches the transfer board.
7.
Remove the back belt.
8.
Loosen the belts until they are very loose. Do not press the buttons in the wrong direction.
9.
Take one of the sling cushion safety bars and unhook it from the sling cushion by passing it back from
the sling cushion hole. Follow the same instruction on the opposite side.
10.
Remove the straps that are hooked into the knee supports.
11.
If necessary, release your feet by removing the Velcro foot band.
12.
With the help of your hands, remove your body and legs out of the device.
13.
Place the sling cushion back on the device.
14.
Activate the remote control (red led will light up).
15.
With the use of either the remote control or the joystick, move the device to a safe position where
you can reach to switch it off and switch the device off.
Summary of Contents for TEKRMD01
Page 1: ......
Page 42: ...41 MUSTS5003_04 20210501...
