21
MUSTS5003_05 20211101
Switching Standard wheel - Large wheel (Tek RMD02, Tek RMD03, Tek RMD04, Tek RMD05).
Lifting Tek RMD off the ground
1.
Place the lifting jack under Tek RMD until the bumper cover touches the metal stopper.
2.
Push the lever arm down. Tek RMD will lift off the ground.
1 (i)
1 (ii)
2
WARNING:
The lifting jack has moving parts which can easily pinch an object with severe force.
Placing fingers or other body parts near the lifting jack while on the floor or while being carried can lead
to serious injury. To avoid pinching, always keep all body parts away from the lifting jack. Do not place
any body part in between the small spaces of the jack. Always detach the lever from the lifting jack
when not in use.
Switching the front wheels
1.
Place the Wheel nut tool in the hub of the wheel on the wheel nut.
2.
Turn the wheels using the remote control to unscrew the nut. The wheels should be driven in
opposite directions to each other to be locked and unlocked. Follow the driving direction sticker.
3.
Pull the tool out. Look inside the tool to make sure the nut is there.
4.
Pull out the wheel out of the shaft.
5.
Place the new wheel on the shaft and push. The shaft has a keyhole, and both the Small and Large
wheels have the screw heads marked with red holding the key on the rim. The keyhole and the
screw head should coincide with each other for the wheel to go in.
6.
Place the wheel nut tool inside the hub of the wheel. Push inside until the nut reaches the shaft.
With the help of the remote control drive the wheels to screw the nut. Feel the resistance to make
sure it is fully secured. Turn the wheel by hand with the wheel nut tool to be sure.
7.
Pull the tool out, look inside tool to make sure the nut is not there. Try pulling on the wheel to
check for tightness.
8.
Repeat for the other side.
1
3
4
5 (i)
5 (ii)
6
7
Summary of Contents for TEKRMD01
Page 1: ......
Page 42: ...41 MUSTS5003_04 20210501...
