Do not install the printer in a place where it may be subjected to
moisture, dust, or splashes of water (rain).
Installation/Storage
Keep the printer away from heat sources, as well as lit candles
and cigarettes.
Keep any flammable liquid, gas, and aerosol away from the printer.
Do not place the product where its vent can be blocked or
interrupted.
Make sure that the product is unplugged when installing it.
(The cable may be damaged and cause fire or electric shock.)
Do not place metal objects, chemicals, or anything with water on it.
Misc.
If you observe smoke, odor, or noise from the Laminat
ion Module
, unplug it
immediately and contact your dealer.
Do not disassemble, repair, or modify the
Lamination Module arbitrarily
Do not remove any cover or protective device that is attached
with screws.
Do not operate the
Lamination Module while your hand is placed inside.
Clean and maintain the
Lamination Module according to the instructions
Do not block the air vent on the product as it can cause
overheating or fire.
Do not install the product as a built-in unit in a place with poor
ventilation.
Make sure that the power cable is properly arranged for your
safety.
Do not place the printer in direct sunlight as it may cause a
malfunction.
Do not place the product on the surface that is not stable
(e.g. bed, sofa).
07
Matica Lamination Module MC-L2 User Manual
In regular use product location
(*Prevention of use when tilted or lay a product on the side)