x 2
b
e
SILICON
a
c
1
1
2
2
STAGE 2
OUTSIDE
FACE
FOR BOTH PANELS
This stage is describing the fitting of both fixed panels. Before fitting the fixed glass panels adjust the threshold extrusion so that it
is equally positioned between the two wall mounts. Loosen the threshold adjusters at each end and lightly tighten in position as
required.
a.
Apply a bead of silicon along the outer inside edge of the threshold extrusion in the recess provided up to the cut-out where both fixed
panels will be fitted.
b.
Remove and set aside the panel stop fixing screws from the threshold extrusion.
c.
Make sure the wall mount glass guard is pushed up fully to allow the glass to easily slot into the wall mount.
d.
Lightly wet the edge of the fixed panel
with soapy water and gently lower the panel down into the threshold extrusion first then along into
the wall mount.
e.
As a guide the end of the edge of the fixed panel glass and extrusion should be positioned inline with the start of the cut out in the
threshold track (d) further slight adjustments may be required during the fitting of the door. Fix into position using the previously removed
screw.
f.
Repeat as above (c-d) for the opposite panel.
WALL MOUNT
GLASS GUARD
SOAPY
WATER
SOAPY
WATER