SILICON
SILICON
SILICON
SILICON
a
b
c
d
e
x 2
SILICON
f
STAGE 6
INSIDE
CAP
This stage is describing the fitting of the covers and caps.
a
. Apply a continuous bead of silicon all around the inside of the troughs in the threshold track between the edge of the fixed panel
and the lower pivot block and between the other side of the lower pivot block and edge of the closure fixed panel, as shown above.
b.
Fit the two covers either side of the lower pivot block into the threshold track, so that the face of the covers is firmly pressed
against the face of the lower pivot block and ensure the slope on the cover is facing inward.
c
. Apply a bead of silicon all around the inside of the recess in the threshold track where the threshold cover caps are to be fitted,
from the edge of the threshold cover all the way around to the edge of the fixed glass panel. Fit the threshold cover caps (supplied in
the kit of parts), with the slope facing inwards.
d.
Fit the upper pivot block covers with colour detail disks over both sides of the upper pivot block and inline panel clamp. The inline
panel clamp covers are factory fitted on the panel for silver, black and white units. Remove and refit with the colour disks. The Inline
clamp covers are not fitted on bronze products or with optional copper and brass handle variants. These are included in the parts kit.
f.
Fit the handle cover caps, press firmly into the ends of the handle.
SLOPE
INWARDS
SLOPE
INWARDS
FIXED
PANEL