a
d
b
b
c
This stage is describing the fitting of the closure panel for a LH Corner, reverse for RH Corner.
a.
Apply a bead of silicon along the outer inside edge of the threshold in the recess provided.
b.
Apply a bead of silicon in the corner extrusion as shown, down the full length of the corner extrusion.
c.
Gently lower the panel down into the threshold extrusion first then along into the corner panel extrusion, the extrusion on the
bottom of the closure panel is offset, the exposed glass edge fits into to the corner extrusion.
d.
Set the distance between the fixed glass panel and closure glass panel using the threshold cover. The threshold cover should fit
tightly between the closure panel glass and the door guide.
d.
Apply a bead of silicon along the inside length of the threshold in the recess at the front of the track where the threshold cover
will fit (d). Clip the threshold cover into the threshold extrusion.
STAGE 5
THIS PAGE SHOWS THE PANEL INSTALLATION FOR A
LH CORNER. REVERSE FOR RH.
SILICON
OUTSIDE
FACE
INSIDE
VIEW
THRESHOLD
COVER
SILICON
SILICON
INSIDE
VIEW
SILICON
