MSC-XD164L Product Manual
>PsetNames
“Startup”
“Preset1”
“Preset2”
“Preset3”
“Preset4”
“Preset5”
“Preset6”
“Preset7”
“Preset8”
“Preset9”
>PsetNames 1
“Preset1”
>PsetNames 1,”MyPreset”
>
The first 2 example commands are query commands. The last assigns “MyPreset” to Preset 1.
3.11.32 PSub Command
Routers and MSC-GCP2U32 only
Preset subtract command. Removes a connection in a preset by setting a Destination or Destination/Level to
“No Change”. This can be used to incrementally create a preset without changing the active matrix routing.
This command changes preset data which is stored and persists through power cycles.
Command
Description
PSub PRESET, DEST
Remove any existing connection to DEST in PRESET for any level.
PSub PRESET, DEST, LEVEL
Remove any existing connection to DEST/LEVEL in PRESET.
Example
>PSub 1,2
>PSub 1,3,2
>
The first command removes any connection to Destination 2 in Preset 1. The second command removes any
connection to Destination 3/Level 2 on Preset 1.
3.11.33 PView Command
Routers and MSC-GCP2U32 only
View presets. Displays the content of one or all presets.
The format of the returned output is “1:S1[,S2] 2:S1[,S2] ...” where the 1: and 2: are incrementing destination
values, followed by one or more source values (depending on the number of system levels).
Special source values
•
'-' indicates “No Change”, which causes no changes to the given Destination/Level.
•
0 indicates “Mute”
Page 43 of 60
© 2013-2018 Matrix Switch Corporation
